Fitting Angel lights on a 106  
Here is a quick guide on how to fit a set of angel lights to a 106 GTi. Two people is advisable when removing the front bumper from the car.

DISCLAIMER: The following quick guide can ruin your car! Beware that you have to read/view the article very well. www.Peugeotperformance.net nor the author is responsible for any damages caused to your car when you follow the steps written in this article.

  Tools & Parts
up

parts:
  • Angel lights
    		•  tools:
  • 10mm socket/spanner
  • Small socket set
  • long reach part (makes the job easier)
    		•
  • pliers
  • trolley jack
  • axel stands
    		•   

      Step 1
    up

    Enlarge picture      
    Disconnect the car battery. Jack up the car to remove the inner front arches via 3 plastic lugs by pulling them off by hand or using pliers. Later we found out you can actually get to the bolt by removing the plastic lug nearest to the bolt. Using the socket & 10mm bit, undo the nut in the arch holding the bumper on.

      Step 2
    up

    Enlarge picture Enlarge picture    
    Using the 10mm socket & a long reach part remove the two bolts behind the front bumper which are situated to the left of the drivers & the right of the passengers side fog light casing at a horizontal angle. The bumper will now slide away from the car.

      Step 3
    up

    Enlarge picture      
    Remove all connectors from the lights, then using a 10mm socket undo the three bolts connecting the head lamp. You will need to remove the head lamp before disconnecting the indicator light connector (just dont forget to reconnect it when putting the angel lights back on!). Now from the standard light you will need to remove the indicator light bulb. All you need to do is twist & pull it to remove it. Vice versa when fitting it to the angel lights indicator section.

      Step 4
    up

    Enlarge picture Enlarge picture Enlarge picture Enlarge picture
    You can now fit your angel lights. Bolt 3 bolts back in. We fed the wiring through & connected the indicator on before bolting it on!. Plug the plugs back in to your angel light. You may be left over with a plug that has 3 pin connectors in it, we taped this up.
    Feeding the live wire we chose to go around the back of the engine bay, to the right of the ecu, tucking it in the cloth padding underneath the scuttle panel & zip tieing it to pipes leading off the master cylinder. The passenger side light 12v mains we tucked away in the fuse box & fed the wire underneath it to the battery. Connected to battery terminal & reconnect battery.

      Step 5
    up

    Enlarge picture Enlarge picture Enlarge picture  
    Check lights work! - In the unlikely event that they dont you can take them back off before putting the front bumper back on. Fit front bumper back on, Fit inner arches if you chose to take them off.Angel-lights fitted!.


    Article written by Nick F.